Review: Volquartsen .17 WSM Autoloader

by
posted on October 30, 2015
** When you buy products through the links on our site, we may earn a commission that supports NRA's mission to protect, preserve and defend the Second Amendment. **
volquartsen_review_f.jpg

The high-velocity, high-energy .17 Winchester Super Magnum rimfire is a welcomed cartridge for many wishing to engage everything from destructive rodents to marauding coyotes, especially in regions where centerfires are noisy, frowned upon or even illegal. But finding a rifle to shoot the world’s fastest rimfire has been a challenge.

Not anymore. Volquartsen, the Iowa gun maker that pioneered the 10/22 custom rifle revolution and then began producing its own high-end, rotary magazine autoloading rifles and handguns, has released its 17 WSM rifle, and it appears ready for prime time.

After cleaning the barrel of our test rifle, a Deluxe model, I mounted a trusty old Bushnell Elite 3200 3-9x50mm scope atop the rifle’s Picatinny rail and hit the bench with high hopes. They weren’t dashed. Winchester’s 20-grain and 25-grain Polymer Tip loads both punched sub-MOA, 5-shot groups at 50 yards. The best cluster went .304”, the worst .528”. At 100 yards the best group opened to .730”, the worst expanded drastically to .905”. How refreshing to see an out-of-the-box rifle perform like that.

Mechanically, everything worked flawlessly. It took a bit of wrestling to figure out how to most easily stuff the 8-round, rotary magazine, but once I mastered that, I was sailing. Through 200 rounds of both bullet sizes, slow-fire or fast, the rifle never hiccuped or even slowed. With the barrel fouled, my last 5-shot group went .730”. I picked up all the brass and found all intact. No split necks or cases. Powder fouling around the breech and bolt face were comparable to that of a 10/22 Ruger after equivalent firing.

Obviously this new auto-loader is built right. Volquartsen engineered it from the ground up, but it will look familiar to Volquartsen shooters because it has the same basic contours and functions as the company's other blow-back rimfire autos. The beefy, rectangular receiver is machined from a block of stainless steel. The bolt is machined from tungsten alloy. It rides on a center-mounted recoil rod and spring and is cushioned by a translucent, polyurethane rod across the rear of the receiver.

The heavy, no-contour, .930-inch diameter stainless barrel is threaded to the receiver with all the serious intent of a centerfire. Free floating, it stretches 20-inches from the breech to the end of the rifling with the last half inch threaded to accept a 2-inch muzzle brake. The rifling twists once every 8.25 inches, and six straight flutes down the middle of the barrel relieve its bulky look. Set in a laminated stock with a full pistol grip and wide, flat fore-end, this 10-pound rifle looks like a serious bench gun and performs like one, yet it is eminently suited for predator calling and picking off pasture and hayfield rodents. Rings and scope brought test rifle weight to 11-pounds, 6 ounces.

With this much mass, a muzzle brake might seem laughable, but it isn’t there to protect sensitive shoulders. It’s there to minimize muzzle flip. You can watch holes appear in paper and see tiny specks of flying grass during near misses on ground squirrels. I was able to stay on the bags and on target shot after shot with barely a nudge to reacquire a precise hold.

The Voquartsen is fitted with a comfortably contoured and smooth type III hard anodized aluminum trigger that breaks consistently a 3.5 pounds. It is blocked by a common cross-bolt safety housed in the front of the trigger bow. The magazine detach lever just behind the magazine well protrudes a half inch below the stock belly. It’s nicely contoured to fit an index finger pushed forward. The 4.3-ounce metal magazine drops out nicely. Two magazines shipped with the rifle.

A high, rising comb Monte Carlo cheek piece raises well above the bore to better fit scope/eye alignment. A thin, solid rubber butt pad is ribbed to prevent slipping off the shoulder.

The 17 WSM Deluxe model ships with an MSRP of $2,035. For more information, go to Volquartsen.com.

Latest

Sandman X In Front Of Bipod
Sandman X In Front Of Bipod

#SundayGunday: Dead Air Sandman X

Dead Air Silencers of Heber, Utah, launched Sandman suppressors 10 years ago. Now, after a decade on the market, the company has released the Sandman X. It’s a professional-grade can ready for heavy-duty use that leverages Dead Air’s decades of experience to optimize sound, balance backpressure and eliminate muzzle flash. For more information, check out this exclusive video.

10 Illuminating Facts About This Age of the Trophy Whitetail

So, here we are in the off-season. Whatever any of us saw from our stands last fall, it is interesting (and to some extent helpful) to know how things are trending with the whitetail herd. So, here are 10 illuminating facts about this age of the trophy whitetail.

NWTF Receives Winchester Legend Award

The National Wild Turkey Federation (NWTF) received the highly coveted Winchester Legend Award during its 50th Convention and Sport Show in February.

Member's Hunt: Grandpa’s Bow

Have you ever tried to explain field dressing over Facetime? Larry Partika attempts just that in this month's featured Member's Hunt. 

First Look: Armageddon Gear Suppressor Caddy

Suppressors aren't cheap, disposable, or easy to replace so how you carry them matters. With that in mind, Armageddon Gear built what it couldn't find anywhere else on the market: a durable solution for storing and transporting cans.

Hardware Review: Burris Fullfield Riflescopes

Now in its fifth generation, Burris’ Fullfield riflescope line has been completely redesigned to be lighter, shorter and stronger than its predecessors. Check out our thorough review of the lineup here.

Interests



Get the best of American Hunter delivered to your inbox.