Have a question you want us to address? Let us know! Send a message to EmediaBullShooters@NRAHQ.org

Is a 25-Yard Zero Dead-On at 100 yards?

By Keith Wood

The Myth: A 25-yard zero puts you “dead-on” at 100 yards. I’ve listened to some pretty amazing ballistic theories over the years but this one is probably the most common. The theory is that, with common big game cartridges, a “zero” at 25 yards will correlate to a second “zero” at 100 yards.

The Ballistic Background: First we have to understand the concept of zero.  Because a rifle’s sights are not inside the bore and a bullet’s flight path is subject to gravity, we must align our sight to intersect with the bullet’s path at a given distance.  Generally, we consider the rifle’s “zero” to be the point at which the bullet’s path intersects the line of sight for the second time.  In other words, if the bullet strikes the line of sight at 25 yards and then rises relative to the line of sight before falling and intersecting the line of sight again at 100 yards, we have a 100 yard zero. 


Let’s look at a few common examples:

.30-06 Federal Premium 165gr. Nosler Partition 2830 fps (Factory)
25 yard zero=2.77 inches high at 100 yards

.270 WCF Winchester Silvertip 130gr. 3060 fps (Factory)
25 yard zero=3.0 inches high at 100 yards

.243 Winchester 100gr Hornady Interlock 2960 fps (Factory)
25 yard zero=2.9 inches high at 100 yards

Fact is, most common big game loads would be about 3 inches high at 100 yards. For hunting purposes it may be "close enough," but it's not "dead on" for most calibers.

The Conclusion: A 25-yard zero will put your bullet around 2.5 to 3 inches high at 100 yards depending on caliber, but it's not "dead on."

Share |



Enter your comments below, they will appear within 24 hours

Your Name

Your Email

Your Comment

25 Responses to Is a 25-Yard Zero Dead-On at 100 yards?

sylas wrote:
December 23, 2014

I usually set my sights about a half an inch low at 25 yards and hit good up to about 400 yards using my BDC sight on my 30-06

Jay wrote:
November 07, 2014

I'm shooting a 300 win mag 150 grain and zeroed at 2 in high at 100 yards. How much will it rise at close yardage like 20, 30, 40 yards?

calvin wrote:
October 02, 2014

I'm shooting a .308 with 180 grain zero 1 in high at 100 yards when I shoot close distance of yards I'm 3 in high is that correct? ???

Bigee wrote:
August 22, 2014

When your shooting your M4 and M1A it is near the same because your using open sights, not a scope.

GP wrote:
July 13, 2014

I have gotten the best results with my 30-06 by setting zero at 50 yards. My 100 yard and 150 yard shots are a little high then I am back to back to zero at 200 yards.

jim m wrote:
April 02, 2014

This does not speak to windage that is fine at 25 yds and no where to be found at 100

Dick wrote:
April 02, 2014

I target shoot with a scope and hunt with an eotech512. I zero both at 25 yards and go to 100 yards from there. You can't miss a running deer with an eotech sight.

Thomas Bates wrote:
August 22, 2013

Thank you all I'm shooting a17hrm and it is shooting 2in.at100yards. Thanks again.

Braonan wrote:
June 17, 2013

Being an infantry drill sergeant, I do a little shooting with the M4/A2/A3. I zero'd a government colt M4 at 25 meters and then shot that same weapon at a target set at 100 meters. While not scientific the government ammo hit the 100 meter target about half an inch high consistently but unless you're shooting competition it isn't going to matter much. Combat/defensive shooting is a different animal than target shooting, so it all depends on what you are planning to do with your weapon and what ammo you shoot. The bottom line is that you shouldn't be basing your shot estimates on what you read, go out and shoot at various ranges to see where you will hit.

Whoofbang wrote:
January 19, 2013

Thr 25 yd and 100 yd zero works with black powder and pistol cartridges, 44 mag, 45-70, 38-55, 357 mag, are a few. It depends on the initial muzzle velocity.

JustMe wrote:
November 20, 2012

For a 30-06 remington cor-lok 180gr a 200 yd zero gives a 25 yd zero(actually 0.1in under), and 308 cor-cok is an inch high at 25yd for a 200yd zero. So not true for 100yd but close for 200yd.

September 08, 2012

does a full metal jacket or blistic tip make any difference???

Joe Locklear wrote:
February 06, 2012

I want to shoot hogs with my Marlin 336 in 35 rem. with a Trijicon 1-4 scope. I would not expect to take a shot past 100 yards. If I zero at 25yards, where should I be on paper for the closest to average zero from 20 to 100 yards?

GS wrote:
November 29, 2011

The purpose of 25 yard zero is not to be dead on at 100 yards but instead to achieve the maximum point blank range of the cartridge. MPBR would normally be up to 3" high at it's highest and 3" low at it's lowest with no need to "hold over" as your chart clearly shows 275 yards for the 30.06. 3" high or low behind the shoulder will still kill a deer.

culring nut wrote:
November 09, 2011

I heard if I can only sight in at 25 yards if I hit the target 1/4" low of center, then at 100 yards I'll be close to right on?

Raff wrote:
July 27, 2011

I sighted a 7mm Rem Mag at 25yds., impact was : 1/2" high at 50yds., 1" high at100yds.,4" high at190yds., dead on at 265yds. (140gr. BallisticTip@3475fps)

KW wrote:
June 17, 2011

Phil, you make a good point which reenforces the theme of the blog: that nothing is ever absolute. "Rules" like these are rarely accurate due to the endless number of variables involved.

Phil wrote:
June 16, 2011

Your figures are based on the line of sight being 1.5" above the center of the bore. It doesn't have to be very different to get significantly different results.

Casual Shooter wrote:
June 16, 2011

@ Richard. No, the .308 round has ballistics very similar to the .30'06. When zeroed at 25 yards, it will also shoot 2+ inches high at 100 yds. The same with the .223. Possibly the .22LR is anemic enough to zero at both 25 yds and 100 yds. But what you're saying is certainly not a fact.

Rich wrote:
June 16, 2011

Over in 'Nam, we had 25 meter ranges outside the wire of our fire support bases. SOP with the Big Red One was zero your 16, always have fresh ammo, it'll keep you alive.

Herman wrote:
June 11, 2011

A 25yd zero on a 30-06 will allow you to kill a deer from 1 to 300yds, your bullet will always be in the killing zone.

Rob Felcher wrote:
June 11, 2011

Always heard this, good to see some real facts.

Jipple wrote:
June 11, 2011

Makes total sense. Good analysis.

Bill Kappele wrote:
June 10, 2011

It seems that people mistake Maximum Point Blank Range (MPBR) sighting for Dead On sighting. Sighting at 25 yards can be useful for MPBR sighting.

Richard wrote:
June 10, 2011

That myth comes from the fact that a 25 yd zero will be a 100 yd zero for the 5.45/.223 & 7.62/.308 rounds. Depending upon temperature and altitude of course.